wiki:GuideParameters

Version 2 (modified by tshalif, 13 years ago) (diff)

--

Table of Contents

  1. Introduction
    1. Features
    2. Device compatibility
    3. Limitations
  2. How to use
    1. Device Tilt
    2. Distance/Speed precision
    3. Graph Zooming
    4. Graph Switching
    5. Recording/Replaying
      1. Recording
      2. Replaying
      3. Sharing
    6. Real Time Remote Viewing (Experimental)
    7. Stroke analysis graphs
  3. Parameters

Parameters

CategoryNameDefault ValueDescription
Autorow stop timeout 5 How many seconds since end of last stroke before finishing a rowing lap when in 'Autorow' mode
Auto Restart Wait Time 5 Number of seconds application must wait before allowed to auto start another rowing lap when in 'Autorow' mode
min amplitude 1.0 Arbitrary min acceleration/deceleration amplitude value must be detected in order for the application to consider it the beginning of a starting stroke when in 'Autorow' mode
Split rowing start/stop mode MANUAL Rowing lap display start mode - in AUTO mode application will automatically start and stop a split rowing session. In SEMI_AUTO mode the rower needs to press the device once to enable each auto-start. In MANUAL mode the rower must press to start and stop split rowing mode. In CONTINUOUS mode the application will immediately enter split mode like as if 'start' was pressed
Rowing Straight Line Mode false Only calculate GPS distance between original start point and current location - if usefull at all, only to be used when the rowing course is completely streight
Sensors coax mode false indicates the device user is forward facing - such as a coax or trainer. Normally the rower sits with her back to the front of the boat
orientation damper 0.01 Lowpass filter used as stabalizer for the 'down' notion of the application
Stroke power filter 0.5 *FIXME*
power filter 5.0 Minimum power (sum of acceleration points) required during a rowing cycle in order for it to register
false session recording on
Stroke stroke amplitude filter 0.05 Lowpass filter to 'smooth' the rowing sinusoids and establish single rise-above/drop-below zero points in each rowing cycle
stroke amplitude change filter 0.5 Lowpass filter to stabalize stroke rate and protect against displaying erratic changes
stroke amplitude change accept filter 0.5 *FIXME*
stroke min amplitude 0.02 Minimum acceleration amplitude required during a rowing cycle in order for it to register
GPS Speed change damper 1.0 Boat speed lowpass filter: any value lower then 1.0 will cause delayed updates of boat speed value
min distance 20 Minimum distance boat must travel between each distance/speed calculation
max speed 6.5 Maximum permited boat speed - useful for catching and throwing away erratic GPS readings